User's Manual

1
2
3
4
use this size
4.4 Man (Manual)
Light output is controlled by fixed power output of flash.
Use this mode if you want the most accurate and repeatable exposures
possible.
4.4.1 Man mode setting
In Manual mode the power can be adjusted from 1/64 to 1/1 in third
stop increments.
4.5 LINK
Light output is controlled by the sensor located on the Pilot. The F
number and ISO information comes from the camera.
This mode provides the accuracy of the Auto setting while eliminating the
need to worry about flash placement. No matter where the flash is
placed the sensor located on the Pilot will ensure that the correct
exposure reaches the camera.
4.5.1 LINK mode setting
You can set the light output 3 stops below or 2 stops above the camera
setting.
Note : There is only one LINK setting possible. If you have two or more
remote flashes in LINK mode they will share the same LINK setting.
4.6 OFF
Prevent the remote flash from firing.
11