User's Manual

use this size

5. Setting up a remote T5D-R

Qflash model T5d-R requires a Free X Wire receiver model FW7Q or

FW8R.

If you are using an FW8R then you will also need an FW31 cable to

connect the FW8R to the Qflash.

Step 1

After connecting the Free X Wire to the Qflash. Connect the Qflash to a

Turbo, Turbo SC, or Turbo 2x2 and turn the power on.

Step 2

Set the channel on the Free X Wire to the channel you will be using on

the Pilot.

Turn all four zones on.

Step 3

Change the mode of the Qflash to Wireless Group 1 or Wireless

Group 2. Note : Qflash T5d-R does not support R3.

You may set up many flashes within a group. All flashes within a group

will be set identically from the Pilot.

There is no limit to the number of flashes for a group.

Step 4

Once you are done setting up the remotes, turn on the Pilot.

The Pilot will send mode and setting information to the remote flashes.