User's Manual

use this size

6. Setting up a remote TRIO

Step 1

Connect the TRIO to a Turbo, Turbo SC, or Turbo 2x2 and turn the

power on.

Step 2

Set the channel on the Free X Wire to the channel you will be using on

the Pilot.

Step 3

Change the mode of the Qflash to Remote Group 1, Remote Group 2,

or Remote Group 3. Note : If your TRIO does not support R3 visit

www.qtm.com for the latest TRIO software.

You may set up many flashes within a group. All flashes within a group

will be set identically from the Pilot.

There is no limit to the number of flashes for a group.

Step 4

Once you are done setting up the remotes, turn on the Pilot.

The Pilot will send mode and setting information to the remote flashes.