User's Manual

use this size
2.1.1 Inserting the “AA” batteries
To access the battery compartment,
unscrew the top housing.
Insert 4 “AA” batteries into the battery
holder located in the lower housing.
Close the top housing .
2.1.2 Using a Quantum Turbo.
The PILOT is powered from a Quantum Turbo using a CQ8 or a CCQ8
cable.
Plug the power cable into the Pilot, then into the output connection of the
power pack.
Leave the PILOT on/off switch in the off (0) position. Use the power
switch on the Turbo to turn the PILOT on or off.
2.2 Restoring Factory settings
You can restore the factory settings by the following method:
1. Turn the PILOT off using the on/off switch located on the top housing,
or by Turning the Turbo OFF if you are using the power cable.
2. Press and hold any button
3. Turn the PILOT ON.
4. The PILOT will display a reset message and some soft key options
See section 7 for display of reset message.
RESET ALL - will restore all the factory settings.
KEEP P1 P8 - will keep your stored Program modes, but reset
everything else to factory settings.
EXIT – will exit the reset menu without changes
You can also reset the PILOT in the OPTIONS menu. See Section 7
3