User's Manual

use this size
3.3 SELECT
This soft key selects one of the following :
Settings for Remote 1 / Settings for Remote 2 / Settings for Remote 3
After the setting that you want to change has been highlighted, use the
Left (-) Å and Right (+) Æ buttons to change that setting.
Each of the modes for the remotes have a setting that can be adjusted.
Below is a description of each mode plus it’s setting.
Man (Manual) 1/8 +
A remote flash set to Man can have it’s power adjusted from 1/32 to 1/1
in one third steps.
Auto F8.0
3
The F/number of a remote flash in Auto can be adjusted in third steps.
The ISO for all remote flashes will come from the camera.
A.Fill (Auto Fill) +1.0
7
In A.Fill, the F/number for the remote flash comes from the camera.
However you can set the remote flash from –3 stops below to +2 stops
above the camera setting.
QTTL -1.0
3
The exposure of the remote flash can be set from –3 stops below to +2
stops above the camera setting.
Linked +1.0
3
This mode uses the sensor located on the front of the PILOT. The
F/number and ISO come from the camera. However you can set the
remote flash from –3 stops below to +2 stops above the camera setting.
3.4 CH.
This soft key is used to change the Channel of the internal radio. The
channel set on the remote Qflashes, needs to match the channel set on
the PILOT.
6