User Instructions

Radio: set Automatically.
Positives : Greatest flexibility in flash set up without leaving camera position.. Multiple flashes
in mixed modes possible.
Negatives : Slower response, not good for action shots. Data transmission occurring before,
during, and after shot. Data transmission can interfere with other photographers in the area.
7.8 AM Advanced Multi
This mode allows the user to have full control over Three remote flash groups. There is no limit
to how flashes can be set to any one group. Mode, F number, power, and even linking the
exposure of a remote flash group can all be set from the push buttons on the local flash.
Radio: Turned on automatically. Set only Channels/Zones to match.
Positives : Possible to set up mixed mode lighting set ups and make changes without walking
over to the remotes. Good mode to use if the remotes are inaccessible.
Negatives : Slow to use, not good for action shots. Data transmission occurring before, during,
and after shot. Data transmission can interfere with other photographers in the area.
8. Radio set up
Press the RADIO soft key to enter the radio set up
menu. To exit the set up menu press the MODE/OK
or SET buttons.
The two soft keys located on the right side are
used to adjust the channel up or down.
The soft key labeled ZONES is used to turn the
zones ON or OFF.
The left most soft key is used to set up the mode of the
radio.
OFF – Radio off no signal sent.
SYNC – Trio sends a sync only signal to remotes. A remote flash can be another Trio, any
Qflash using an FW10w, FW8R, FW7Q or any studio strobe using an FW10w, FW8R. Tx will
appear in upper left corner of display.
RX – Trio will fire when local flash sends a sync signal. Local flash can also control exposure of
Trio set to RX. Local flash can be a Trio, a Qflash 5d-R using an FW10w or FW9T, or a QTTL
adapter with an FW9T. Rx will appear in upper left corner of display.
LINK / QTTL – Trio will send a sync signal plus exposure control signals to Remotes. A remote
flash can be another Trio or Qflash 5d-R using an FW10w or FW7Q. Tx will appear in upper left
corner of display.
For a group of flashes that will fire together, set all units to the same chanel. Within each
channel you may set units to different zones. Use different zones when you wish to tunr off
some, but not all the remote flashes.
Page 11
MO D
E
/OK
SET
RADIO OFF
OFF
SYNC
RX
LINK
ZONE
S
CH.4
↑ ↓
OFF