User Instructions

Two subjects separated by a gap
Sometimes two subjects are separated by a gap.
When this occurs the sensor is ‘looking’ between
the two subjects and may miss them. The
Sensor Limit will correct for this by reading only
the light from objects within the limit set, in this
case, 15 feet. The light from objects further
away will be ignored.
With the Sensor Limit it is no longer necessary for the subject to be
centered in the frame. As long as the subject is within the Sensor Limit
12. QR QTTL Ratio Mode Operation
F/number, ISO are sent to the flash from the camera.
Local fill setting (on camera flash), R1 ratio,
and R2 ratio are user adjustable. Pressing the
Set button will highlight them in that order. Use
the left  and right  arrow buttons to adjust
the highlighted setting up or down.
When you Press the Set button, an ON/OFF soft
key will appear on the right of the display. You can
use this soft key to prevent the Local, R1 or R2 flashes
from firing.
To prevent a flash from firing, press the Set button until the flash you want to turn off is
highlighted. Then press the OFF soft key, the word “OFF” will appear next to that flash.
Using the Radio
The internal radio will be turned on automatically, but you may still need to select the proper
channel to match the channel on the Remote flashes. See section 8.0 for setting the channel
and zones on the Trio
The remote flashes may be a Trio or a Qflash model 5d-R with a FW7Q or FW8R.
If the remote flash is another Trio then it must be set to RG remote group mode.
If the remote is a model 5d-R, select either Wireless Remote Group R1 or Wireless Remote
Group R2.
Page 18
MO D
E
/OK
SET
FIRE
OPT
SAVE
RADI
O
QTTLWR
F 5.6
7
FILL +0
ISO 200
R1 +1
R2 -1