User Guide

28 www.quantumrehab.com Quantum 1107
V. COMFORT ADJUSTMENTS
3. Reinstall the quick release fasteners into the foot platform
bracket and tighten.
Foot Platform Depth Adjustment
To adjust the foot platform depth:
1. Remove the quick release fasteners from the foot platform
bracket. See figure 21.
2. Move the foot platform in or out to the desired depth.
3. Reinstall the quick release fasteners into the foot platform
bracket and tighten.
Quick Release Fasteners
The foot platform is attached to the power base with two
quick release fasteners. See figure 21. Each quick release
fastener consists of a bolt, a lever, and a nut. See figure 22.
The lever has a cam on the end that allows it to clamp into
place. The quick release fastener has two states: clamped
and unclamped. When the lever is open, the quick release
fastener is unclamped. When the lever is closed, the quick
release fastener is clamped.
To clamp the quick release fastener:
1. Make sure the lever is in the open position.
2. Turn the nut clockwise until it is snug.
3. Rotate the lever until it is in the fully closed position.
NOTE: If the lever will not rotate to the fully closed
position, then turn the nut counterclockwise one-quar-
ter or one-half turn.
Foot Platform Angle Adjustment
You can adjust the angle of the foot platform with a hex key.
See figure 23.
To adjust the foot platform angle:
1. Flip up the foot platform and locate the setscrew.
2. Turn the setscrew counterclockwise to raise the front
of the foot platform.
3. Turn the setscrew clockwise to lower the front of the
foot platform.
Figure 24. Swing-Away Footrests
FOOTREST
ADJUSTMENT
SCREWS
FOOTREST
EXTENSION
SFR RELEASE LEVER
Figure 23. Underside of Foot Platform
SETSCREW
BOLT
NUT
CAM
Figure 22. Quick Release Fasteners
LEVER (OPEN)
UNCLAMPED
LEVER (FULLY CLOSED)
CLAMPED
Foot Platform Height Adjustment
The foot platform height is easily adjusted to different heights
in 1/2-in. increments.
To raise or lower the foot platform:
1. Remove the quick release fasteners from the foot platform
bracket. See figure 21.
2. Raise or lower the foot platform to the desired height.