User's Guide

Quantum Bezel Replacement Guide
Document 81-81252-05 A01
October 2006
11
DLT VS160/DLT-V4 Bezel Replacement 0
Tool Needed 0 Small flat-head screwdriver or similar tool.
Remove the Existing Bezel 0 1 Place the tape drive on its left side.
2 Hold the right side of the bezel. Press down gently on the right bezel tab
(through the tab slot) while pulling the bezel away from the tape drive
(see figure 1
).
Figure 1 VS160/DLT-V4
Removal
3 Remove the bezel from the tape drive. Verify that the door spring is still
in place on the bezel.
Note: The tape drive and bezel may look different from the illustration.
The illustration shows an DLT VS160 tape drive.
Caution: Do not use anything that could break off inside the tape
drive (like a pencil tip). Use a small flat-head screwdriver
or a similar tool.
Right tab
slot