User's Guide

Quantum Bezel Replacement Guide
Document 81-81252-05 A01
October 2006
6
Bezel Replacement Guide Overview 0
Introduction 0 This guide contains instructions for removing and installing front bezels for
the SDLT 320, SDLT 600, DLT-S4, DLT VS160, and DLT-V4 tape drives. You
can change the appearance of the tape drive by removing one bezel and
replacing it with another.
Naming Conventions
Used in This Guide
0
This guide uses specific terms to refer to parts of the tape drive and bezel.
Figure 1
identifies the terms used in this guide.
Figure 1 Drive Terms
Important Instructions0 Read these instructions before you begin. They will help make replacing the
bezel safer and easier:
• Read and follow all instructions carefully. If you damage the tape drive
while removing or replacing the bezel and tape drive failure occurs as a
result, you may invalidate your warranty.
• Use the appropriate instructions for your model of tape drive. The
instructions differ significantly.
• Be careful not to damage or scrape off the surface-mounted LEDs behind
the bezel on the front of the tape drive.
• Bezel replacement cannot be performed with the tape installed.
Note: The tape drive and bezel may look different from the illustration.
The illustration shows an SDLT 600 tape drive.
Left side of
tape drive
Left side
of bezel
Right side of
tape drive
Right side
of bezel
Bottom
of bezel
Top
of bezel
Rear of
tape drive