User's Guide

Quantum Bezel Replacement Guide
Document 81-81252-05 A01
October 2006
9
SDLT 600/DLT-S4 Bezel Replacement 0
Tools and Supplies
Needed
0
Locate these tools and supplies before you begin:
• X-Acto
®
knife or small flat jeweler’s screwdriver
• T-8 TORX
®
-bit screwdriver (supplied with SDLT 600 tape drives)
• T-10 TORX-bit screwdriver (supplied with DLT-S4 tape drives)
• DLTtape
®
decal (supplied with the tape drive).
Remove the Existing Bezel 0Two mounting screws attach the bezel to the tape drive. The DLTtape decal,
when affixed, hides the screws. An adhesive (PSA) holds the decal in place,
which can be removed and then reattached to the tape drive no more than
twice (see figure 1
).
Figure 1 SDLT 600/DLT-S4
Removal
1 Carefully slide the blade of a knife or flat jeweler’s screwdriver under the
left edge of the decal to loosen it (see figure 1
). Use your fingers to
carefully peel the decal off the bezel.
Note: The tape drive and bezel may look different from the illustration.
The illustration shows an SDLT 600 tape drive.
Note: There is no adhesive on the left edge of the decal; this makes
removal easier.
Mounting screws and decal locations
Loosening the decal