Operator's Guide

Chapter 1 Introduction
Operator Accessible Components
Quantum|ATL 7100 Series Library Operator’s Guide 7
Table 1 Controls on
the Control Panel
Control Library Function
OPEN
(load port)
The
OPEN button opens the load port door providing access to the four
loading bins. When pressed, the following occurs:
1. Park the robotics (green indicator blinks).
2. Unlock and open the load port door (green indicator illuminated).
3. Lock the load port door in the open position (green indicator off).
CLOSE
(load port)
The
CLOSE button closes the load port door. When pressed, the
following occurs:
1. Park the robotics (red indicator blinks).
2. Unlock the door (red indicator illuminated).
3. The operator closes the door (red indicator illuminated).
4. The library locks the door in the closed position (red indicator off).
STANDBY The STANDBY button toggles the library between online mode and
standby mode.
On-line mode —normal operation, the red indicator is Off.
Standby mode — host communications are disabled, the control panel
menu mode is available, the diagnostic port on the rear panel (
DIAG) is
active, and the red indicator is On. If chosen during a transfer operation,
the library completes the operation before standby mode is active (the
red indicator blinks during the completion of the transfer).
STOP
The STOP button removes power to the robotic equipment (red indicator
illuminates). Pressing the button again restores power to the robitics (red
indicator off).
SELECT
↑↓
With the library in STANDBY mode, pressing the
SELECT button
activates the menu mode. In menu mode, a menu appears in the bottom
line of the status display area (SDA). An operator then uses the
↑ and ↓
buttons to scroll menu options in the SDA. When the desired menu
option is displayed, the operator then chooses the SELECT button.
For detailed procedures on using the menu mode, see Chapter 3,
Operator Troubleshooting
.