Operator's Guide

Chapter 3 Operator Troubleshooting
Status Messages
48 Quantum|ATL 7100 Series Library Operator’s Guide
Table 5 Status
Messages
Status Message Description/Action
System On-line. The library is online and ready to communicate with the host
computer.
System Off-line. The library is offline and ready to accept commands from the
diagnostic PC (
DIAG port) or enter the control panel menu mode.
Going On-line...
Please Wait
.
The library is transitioning from offline to online but must complete
a command that is (currently) executing. When finished,
System
On-line
is displayed in the SDA.
Going Off-line...
Please Wait
.
The library is transitioning from online to offline but must complete
a command that is currently executing. When finished,
System Off-
line
is displayed in the SDA.
System Power-Up. This is the first message displayed in the SDA when the library
power is cycled from off to on.
Initializing...
Wait for On-line
This is the second message displayed in the SDA, after System
Power-Up
, when the library power is cycled from off to on. When
the library successfully completes initialization,
System On-line is
displayed.
On-line Init Fail In the event of an initialization failure (library power has been cycled
from off to on), this message is displayed in the SDA following the
Initializing...Wait for On-line message. (When the library
successfully completes initialization,
System On-line is displayed in
the SDA.)
System Stopped The control panel STOP button was pressed.
System DoorOpen The library front door is open.