User's Manual

Quantum|ATL 7100 Series Library Unpacking Instructions
Document 6241100-03, Ver. 3, Rel. 1
August 2001
16 Installation Procedures
Leveling the Library 0
To level the library:
1 Lower each foot of the library until it makes contact with the floor
(see figure 9
).
2 Apply a 1/4 turn clockwise with the open-end wrench to tighten
each foot against the floor.
3 Center a carpenter’s level on the top front edge of the library.
4 Check the gauge on the level. If the front of the library is level, go
to the next step. If it is not level:
a Determine the tilt of the library.
b Lower the foot on the low side by applying a 1/4 turn with the
open-end wrench.
c Repeat until the front is level.
5 Repeat the previous step for all edges of the library.
6 Recheck the level on all top edges.
To continue installation procedures, refer to the Quantum|ATL 7100
Series Facilities Planning and Installation Guide.