Installation Guide

Chapter 2 Unpacking the Library
Unpacking the Library
ACL 4/52 Facilities Planning and Installation Guide 7
Unpacking the Library
2
Caution: Use care when cutting the steel bands that secure the
library and packing materials to the pallet. These bands are
under tension and may snap when cut.
1 Cut the steel bands that secure the library and packing material to
the pallet (see figure 7).
2 Lift the cardboard top cover off the pallet.
3 From the back of the container (opposite the ramp side), pull the
three cardboard retaining clips to their open position, and unwrap
the cardboard box from the library
Figure 7 Removing the
Box from the Pallet
4 Lift the foam cap and accessories tray off the library (see figure 8).
5 Remove the stop block located underneath the library.
TA00139a
Ramp Side
(
Front/Off-load Side)
Top Cover
Steel Bands
Foam Cap and
Retaining
Clip (x3)
Cardboard Box
Pallet
Accessories Tray
TA00140a
➀
➁
➂