Installation Guide

Chapter 2 Unpacking the Library
Moving the Library to the Installation Site
10 ACL 4/52 Facilities Planning and Installation Guide
Moving the Library to the Installation
Site
2
Caution: The library weighs approximately 335 pounds. It is
recommended that at least two individuals perform the
following procedure.
To move the library to the installation site:
1 Prepare the path to the installation site.
The library has a nominal floor clearance of 0.75 inch (1.9 cm). Use
plastic or rubber mats to roll the library over carpeting, floor cracks
and depressions, or door jambs.
2 Verify that all leveling feet are fully retracted (in the up position).
If they are not, rotate each of the feet clockwise until fully retracted.
3 Roll the library to the final installation site.
Any side of the library can be used to push the library but the
preferred side to push from is the front of the library.
Caution: When pushing from the front, be careful not to push on the
following nonstructural parts: load port door, control
panel, front door, or the front door handle.