Installation Guide

Appendix B Supplemental Installation Procedures
Defining the Library Power-Up State
32 ACL 4/52 Facilities Planning and Installation Guide
Defining the Library Power-Up State
2
You have the option of defining the starting condition of the library,
either
On-line
or standby (
Off-line
), after power-up, self-tests and
initialization has occurred. The default is
On-line
. You can change it by
using the
Power-Up State
sub-menu as follows:
1
Press and release the Control Panel
STANDBY
button and verify
that the SDA shows
System Off-line
.
2
Press and release the
SELECT
button to enter the Menu Mode.
3
Verify that the following is displayed in the SDA:
4
Press and release the
SELECT
button to choose the
Configuration
menu.
5
Verify that the following is displayed in the SDA:
6
Use the
↓
button to bypass the
SCSI Address
menu and verify that
the following is displayed in the SDA:
7
Press and release the
SELECT
button to choose the
Power-Up State
menu and verify that the following is displayed in the SDA:
Note:
System On-line is the default. If you want to change the power-up
state to standby mode (
System Off-line ), proceed to Step 8. Otherwise,
exit the menu mode.
8
Use the
↓
button to bypass the
On-Line
option and verify that the
following is displayed in the SDA:
9
With the desired option displayed on Line #2, press and release the
SELECT
button.
Menu:
Configuration..
Menu: Configurati
Inquiry
Menu: Configurati
Power-Up State
Menu: Power-Up
On-Line<
Menu: Power-Up
Standby