Installation Guide
Appendix B Supplemental Installation Procedures
Enabling/Disabling the Auto-Clean Option
ACL 4/52 Facilities Planning and Installation Guide 35
6
Press the
↓
button four (4) times to bypass the
Inquiry
,
SCSI
Address, Power-Up State,
and
Num of Drives
menus. Then verify
that the following is displayed in the SDA:
7
With
Auto Clean
displayed on Line #2 of the SDA, press and
release the
SELECT
button and verify that the following is
displayed in the SDA:
Note:
“Disabled” is the default. If you want to change the automatic cleaning
state to “Enabled,” proceed to Step 8. Otherwise, exit the Menu Mode.
8
With the desired option displayed on Line #2, press and release the
SELECT
button.
9
Press and release the
↑
or
↓
button to clear the resulting display
from the command.
10
Press and release the
↑
or
↓
button and the
SELECT
button
simultaneously, and verify that
System On-line
or
System Off-Line
is displayed in the SDA.
Menu: Configurati
Auto Clean..
Menu: Auto Clean
Enabled