Installation Guide

Appendix B Supplemental Installation Procedures
Enabling/Disabling the Auto-Load Feature
36 ACL 4/52 Facilities Planning and Installation Guide
Enabling/Disabling the Auto-Load
Feature
2
This feature of the ACL 4/52 library enables the operator to load
cartridges into the fixed storage array (FSA) without any intervention
from the host controller. When this feature is
Enabled
, the library will
automatically find bins in the FSA for cartridges that are placed in the
load port. If no bin locations are available in the FSA, the cartridges
will be left in the load port bin and an error message will be displayed
on the control panel SDA.
The default configuration for this feature is Disabled. To enable this
feature on the library, perform the following procedures:
1
Press and release the Control Panel
STANDBY
button and verify
that the SDA shows
System Off-line
.
2
Press and release the
SELECT
button to enter the Menu Mode.
3
Verify that the following is displayed in the SDA:
4
Press and release the
SELECT
button to choose the
Configuration
menu.
5
Verify that the following is displayed in the SDA:
6
Press the
↓
button six (6) times to bypass the
Inquiry
,
SCSI
Address
,
Power-Up State
,
Num of Drives
,
Auto Clean
and
Retries
menus. Then verify that the following is displayed in the SDA:
7
With
Auto Load
displayed on Line #2 of the SDA, press and release
the
SELECT
button and verify that the following is displayed in
the SDA:
Note:
“ Disabled” is the default state for the auto-load option. If you want to
change this feature to “Enabled,” proceed to Step 8. Otherwise, exit
the menu mode.
Menu:
Configuration..
Menu: Configurati
Inquiry
Menu: Configurati
Auto Load..
Menu: Auto Load
Disabled