Installation Guide

Appendix B Supplemental Installation Procedures
Performing an Inventory
ACL 4/52 Facilities Planning and Installation Guide 41
Performing an Inventory
2
This feature allows you to perform an inventory of the cartridges
contained in the library. The inventory information is then written to
nonvolatile RAM. To perform this function, use the
Inventory
sub-
menu as follows:
6
Press and release the Control Panel
STANDBY
button and verify
that the SDA shows
System Off-line
.
7
Press and release the
SELECT
button to enter the Menu Mode.
8
Verify that the following is displayed in the SDA:
9
Press the
↓
button five (5) times to bypass the
Configuration
,
Drive
Control
,
Calibration
,
System Test
and
Robot Control
menus. Then
verify that the following is displayed in the SDA:
10
Press and release the
SELECT
button to choose the
Diagnostics
menu and verify that the following is displayed in the SDA:
11
Press the
↓
button five (5) times to bypass the
Home All
,
Selftest
All
,
Status Actuator
,
Status Sensor
and
Move Actuator
sub-menus.
Then verify that the following is displayed in the SDA:
12
With
Inventory
displayed on Line #2, press and release the
SELECT
button.
Note:
With a full library, the inventory process will take less than three
minutes if all of the cartridges are properly bar code labeled. The
actual inventory time can take longer if the library is not completely
full or if any of the cartridges are not properly labeled. When the
library is full of unlabeled cartridges the inventory process will take
over twenty-seven minutes to complete.
Menu:
Configuration..
Menu:
Diagnostics..
Menu: Diagnostics
Home All
Menu: Diagnostics
Inventory