Installation Guide

Appendix B Supplemental Installation Procedures
Turning the Interior Light On/Off
ACL 4/52 Facilities Planning and Installation Guide 43
Turning the Interior Light On/Off
2
Note: The Interior light bulb is not operator replaceable. Notify your Field
Service Engineer to replace the bulb.
The library is normally shipped with the interior light set to the “On”
position. Use the following procedure to turn the interior light “On” or
“Off .”
Refer to
Figure -2.
1
Press the control panel
STANDBY
button and verify that “
System
Off-line”
is displayed in the SDA.
2
Press the control panel
STOP
button.
Warning: To prevent injury from moving components, always press
the control panel
STOP button before opening the front
door.
3
Using a 5/32” hex wrench, unlatch the front door.
4
Open the library front door.
Note: The front door is the only access for manually turning the interior light
On or Off.
Note: Reach through the front door and set the light switch (located on the
far side of the light) to the desired position.
5
Close and latch the library front door.
6
Press (to release) the control panel
STOP
button.
7
Press (to release) the control panel
STANDBY
button and verify
that the library completes the initialization sequence, and
“System
On-line”
is displayed in the SDA.