Operator's Guide

22
Operatin
g
Procedures
2
This section contains procedures for executing the following
operator tasks:
• Applying and removing power
• Placing the library on-line or taking it off-line
• Inserting and removing tape cartridges using the load port
• Manually unloading a tape cartridge from a DLT tape drive
Applying Power to
the Library
2
To apply power to the library:
1 Verify the following:
a Front door and load port closed
b All outer skins attached
c All rear panel connections secured
2 At the rear panel, set the AC power switch to the | (on)
position.
3 After several seconds, verify that SDA shows
System On-line
.
Note:
System On-line is only displayed if the library power-up state is
configured for
On-line . Otherwise, System Off-line is displayed in
the SDA. (See Chapter 3, “Operator Troubleshooting,”)
Placing the Library
On-Line
2
To place the library on-line:
1 With the library power applied and the SDA showing
System
Off-line
, press the control panel
STANDBY
button.
2 Verify that
System On-line
is displayed in the SDA.
Taking the Library
Off-Line
2
To take the library off-line:
1 With the library power applied and the SDA showing
System
On-line
, press the control panel
STANDBY
button.
2 Verify that
System Off-line
is displayed in the SDA.