Operator's Guide

Chapter 2 Operating Procedures
Operating Procedures
ACL 4/52 Operator’s Guide 23
Removing Power from
the Library
2
To remove power from the library:
1 Press the control panel
STOP
button.
2 Press the control panel
STANDBY
button and verify that
System
Off-line
is displayed in the SDA.
3 At the rear panel, set the AC power switch to the
O
(off) position.
Inserting Tape
Cartridges
2
To insert a tape cartridge:
Caution:
DO NOT USE CompacTape I, CompacTape II

or CompacTape
IIIXT tape cartridges in this library.
Caution:
Examine all cartridges before loading them into the library
or tape drive. Look for label stock or other foreign material
that may be clinging to the cartridges.
1 Press the load port
OPEN
button and verify the indicator begins
blinking. (It may require several seconds for the load port door to
automatically open.)
Warning:
Mechanical hazards could be exposed when the load port is
partially open or closed. Do not attempt to insert hands or
fingers into the load port opening at any time.
2 With the load port door open, place the tape cartridge(s) in any
available bin. (The proper orientation for tape cartridge insertion is
shown in figure 12 on page 24).
3 Press the load port
CLOSE
button.
Caution:
The load port door is locked in the open position. You must
press the
CLOSE button before attempting to close the load
port door.
4When the
CLOSE
indicator is steadily lit, push the load port door
closed. (The library will lock the door.)