Operator's Guide

Chapter 2 Operating Procedures
Operating Procedures Using the Menu Mode
ACL 4/52 Operator’s Guide 33
9 With the proper SCSI ID number displayed on line #2, press the
SELECT
button.
10
Exit
the menu mode.
Note: After changing the SCSI address of the drives, one of three
things must happen to set the new SCSI ID. The Reset Drives
command must be performed from the Diagnostic Software
Package, the host controller must issue a “SCSI Bus Reset,” or
the library must be powered off and on again.
Defining the Library
Power-Up State
2
To define the library power-up state:
1 Enter the menu mode.
2 Press the
SELECT
button to choose the
Configuration
menu and
verify the following is displayed in the SDA:
3 Use the
↓
button to bypass the
Inquiry
menu and verify the
following is displayed in the SDA:
4 Press the
SELECT
button to choose the
Power-Up State
menu and
verify the following is displayed in the SDA:
Note:
System On-line is the default. If you want to change the power-
up state to standby, proceed to step 6. Otherwise, exit the menu
mode.
5 Use the
↓
button to bypass the
System On-line
option and verify
the following is displayed in the SDA:
6 With the desired option displayed on line #2, press the
SELECT
button.
7 Exit the menu mode.
Menu: Configurati
Inquiry
Menu: Configurati
Power-Up State
Menu: Power-Up St
On-line<
Menu: Power-Up St
Standby