Operator's Guide

Chapter 2 Operating Procedures
Operating Procedures Using the Menu Mode
ACL 4/52 Operator’s Guide 37
Adjusting the Display
Area Contrast
2
To adjust the display area contrast:
1 Enter the menu mode.
2 Press the
SELECT
button to choose the
Configuration
menu.
3 Verify the following is displayed in the SDA:
4 Use the
↓
button to bypass the
Inquiry, SCSI Address
,
Power-Up
State
,
Auto Clean
,
Retries
,
Auto Load
and
Language
sub-menus
and verify the following is displayed in the SDA:
5With
Set View
displayed on line #2 of the SDA, press the
SELECT
button and verify the following is displayed in the SDA:
Note:
Contrast 5 is the default contrast setting. If you want to change the
contrast, proceed to step 6. Otherwise, exit the menu mode.
6 Use the
↑
and
↓
buttons to navigate to the desired contrast.
Contrast 9
Contrast 8
Contrast 7
Contrast 6
Contrast 5<
Contrast 4
Contrast 3
Contrast 2
Contrast 1
Exit
7 With the desired contrast displayed on line #2, press the
SELECT
button.
8 Exit the menu mode.
Unloading a Drive
2
To unload a drive:
1 Enter the menu mode.
Menu: Configurati
Inquiry
Menu: Configurati
Set View
Menu: Set View
Contrast 9