Operator's Guide

Chapter 2 Operating Procedures

Operating Procedures Using the Menu Mode

ACL 4/52 Operator’s Guide 41

3 Press the

SELECT

button to choose the

Diagnostics

menu and

verify the following is displayed in the SDA:

4 Press the

↓

button five (5) times to bypass the

Home All

Selftest

All

Status Actuator

Status Sensor

and

Move Actuator

sub-menus.

Then verify the following is displayed in the SDA:

5With

Inventory

displayed on line #2, press the

SELECT

button.

Note: With a full library, the inventory will take less than three

minutes if all of the cartridges are properly bar code labeled.

The actual inventory time can take longer if the library is not

completely full or if any of the cartridges are not properly

labeled. When the library is full of unlabeled cartridges the

inventory will take over twenty-seven minutes.

6 When the SDA returns to the previous menu as shown below (i.e.,

inventory is complete), exit the menu mode.

Menu: Diagnostics

Home All

Menu: Diagnostics

Inventory

Menu: Inventory

Success