Installation Guide

Hardware Installation 11
device and the last drive in the external chain. The terminators on the SCSI host adapter would be removed.
See your SCSI host adapter manual for directions on removing the terminators on the board.
4 Is there a terminator installed on each end of the SCSI bus?
Note
Single-ended termination can be active or passive. ADIC
recommends using only active termination on a single-ended
bus.
Installing the Backup Software
At this point, please refer to your backup software installation guide and install the backup software.
4 After you have completed installation of your AIT-70D/100D and the backup software, you should run a
small backup/restore and compare to confirm that your unit is operating correctly. See your software
installation guide for further information.