Installation Guide

38 Index
— A —
AC Power Connector, 4
Active Head Cleaner, 2
active termination, 14
ADIC Technical Assistance Center, 7, 24, 29, 33
Advanced Intelligence Tape, 38
AIT, iii, 2, 3, 6, 36, 38, 39
AIT data cassette, 5
ALDC, iii, 2
AME, 2, 38
application software, 2, 22
Application Software, 7
ASPI, 3
— B —
backup software, 14
Bad environment, 31
Busy LED, 4, 16, 30, 36
— C —
cassette status, 28
Causes of the Media Warning Message, 31
Check the Terminating Resistor, 13
cleaning cassette, 24, 25, 38
Cleaning Request message, 2, 24, 36
Cleaning Tape, 18
Cleaning the Enclosure, 25
Cleaning the Tape Heads, 24
compressed mode, 5
Connecting More than One 70D/100D, 12
Copyright Notice, iii
Copyright Notice (Europe), iv
— D —
Declaration of Conformity, vi
Defective drive, 31
Dirty ("Stained") heads, 31
DLC, iii, 2, 38
drive fault conditions, 28
drive firmware, 24
drive head cleaning, 31
Drive LED Status, 28
drive LEDs, 28, 31
Drive Operating Condition, 19
Drive State, 17, 18
drive status, 2, 4
dust contamination, 31
— E —
eject button, 4, 21, 22
electrical interference, 31
EMI/RFI Compliance, v
Erasing, 18
error codes, 28
error messages, 2, 4, 28, 32
Error Rate Warning, 24
extreme environmental conditions, 2
— F —
ferrite bead, 38
file access time, 2
Flash memory IC, 5
front panel LCD display, 38
— H —
heat, vii, 31
helical scan device, 5
hierarchical storage management, 38
High Humidity, 31
host adapter, 10, 11, 13
host computer, 4, 7, 10, 11, 16, 38, 39
host system, 7, 16, 20
hosting environment, 3
HSM, 38
— I —
Installing the Backup Software, 14
Installing the Host Adapter, 10
interface cable, 4, 11
— J —
jack screws, 11
— L —
label, 20, 25
LCD, 2, 4, 16, 17, 18, 20
LCD Error Message, 28