User's Guide

Operating The AML/E System
page 5 - 32 Operator Guide 599 DOC C00 003
d) Load the handling boxes removed or the problem box. Begin left in the bottom
row (opening of the box facing you).
The I/O unit is divided in input, output and foreign areas:
- MVS, HACPARM1 in the LDEV commands,
- all other operating systems: archive catalogue (type of archive coordinate)
e) Put the loaded handling boxes back into the I/O unit.
f) Close the I/O door.
- The door retaining mechanism must audibly latch into place.
- The <OPERATOR> lamp will blink if not all boxes are inserted correctly.
- The shutter opens automatically.
- The <OPERATOR> lamp and the luminous push-button <ON> switch off.
Information
Therefore remove only handling boxes you want to load.
Information
If cartridge storage compartments are defined as Eject in the configuration
the AMU, through ROBAR, carries out an automatic inventory of these com-
partments after manual access.
System media
System media have a Volser.
The handling unit identifies the medium by its barcode label and reports the volser
to the AMU.
Foreign (non-system) media
Non-system media do not have volsers readable for the AML/E system.
• They are not identified by a barcode label.
• They are not accepted into the archive.
Non-system media are always located in compartments reserved for non-system
media in the handling boxes. They are processed directly from these compart-
ments.
ATTENTION!
The compartment number and the input at the AMU must be identical.