User`s guide

Chapter 2 Installing Internal Tape Drives
Installing the Tape Drive
11 Quantum DAT 320 User’s Guide
Mounting Screws
Other server models only require the use of special locating screws with
no mounting rail.
1 Use a screwdriver to attach the appropriate screws. You may need
to purchase the M3 screws separately. Position the screws (see
Figure 3
).
Figure 3 Attaching Mounting
Screws
2 Attach the appropriate mounting hardware. Refer to the
manufacturer’s documentation for instructions.
• If you are installing on a server that requires a tray, place the
tape drive in the tray.
• If you are installing in a server that requires mounting rails,
fasten the rails to the tape drive.
• Some servers have snap-on mounting rails attached to the filler
panel. These can be removed and attached to the tape drive
with screws.
Installing the Tape Drive
Slide the tape drive into the open bay aligning the tray or rails with the
slots in the bay (see Figure 4
).