User`s guide

Chapter 2 Installing Internal Tape Drives
Attaching Power and USB Cables to the Tape Drive
Quantum DAT 320 User’s Guide 14
to the server’s external port and a Type A USB socket on the other side.
Make sure you orientate the bracket correctly when you fit it (see
Figure 6
).
1 Remove a spare blanking plate from the rear panel of the server.
2 Fit the bracket with attached the cable and fix it to the server. Make
sure the cable is outside of the server and connect it to the server’s
external USB port (see Figure 6
).
3 Attach the standard USB cable to the bracket (type A connector)
(see Figure 6
).
Figure 6 Connecting the USB
Cable
Attaching Power and USB Cables to the Tape Drive
Note: The drive is not powered from the USB bus. It must be
connected to the server's power supply.
Type B connector
to tape drive
Type A connector on
inside of bracket
Type A connector to
server’s external
USB port