User`s guide

Chapter 2 Installing Internal Tape Drives
Securing the Drive
Quantum DAT 320 User’s Guide 16
Securing the Drive
Note: The server latches and side views of your server model may not
be exactly the same as shown in the illustrations. Please refer
also to your server documentation.
No Mounting Hardware Used
1 Use M3 screws. Check that the holes in the chassis are aligned with
the holes in the sides of the drive and use a regular Phillips
screwdriver to secure the M3 screws (see Figure 8
).
Figure 8 Securing Drive, No
Mounting Hardware Used
2 Ensure blanking plates are in place over empty bays and replace the
cover on the server.
M3 screws, supplied
with tape drive