User`s guide

Chapter 1 Introduction
LED Action Sequences
Quantum DAT 160 User’s Guide 4
Figure 2 Front Panel
Components
LED Action Sequences 1
Table 2 shows the different pattern sequences of the DAT 160 front-panel
LEDs.
Table 2 LED Action
Sequences
LED Sequence Cause Action required
Clean Tape Media Ready
All LEDs OFF.
Drive may not have power,
may be faulty, may have been
power cycled or reset during
a firmware upgrade, or there
is no media present.
Make sure the drive is switched on.The power on/off
switch incorporates a green LED.
If this is not on, check the power cable connection and
replace the cable if necessary. You can use the power
cable from your monitor or another device to check
that the connection is working.
If the power supply is present and all LEDs remain off,
power cycle or reset the drive. If it still fails, call for
service.
Clean
LED
(green)
Tape
LED
(green)
Drive
LED
(amber)
Eject
Button
Ready
LED
(green)