User`s guide

Chapter 2 Installing Internal Tape Drives

Installing Your Drive

Quantum DAT 160 User’s Guide 10

Figure 3 For SCSI Drives Only

— Internal Tape Drive Jumper

Settings

Procedure 2

1 Determine whether you need to change the SCSI ID from the default

of 3.

2 Change the tape drive’s SCSI ID, if necessary.

The SCSI ID is set using jumpers on a set of pins at the rear of the

drive, as shown in figure 3. Use tweezers or small pliers to move the

jumpers to the pattern corresponding to the ID you want. Do not

remove the TP jumper. It should always be set.

Default jumper settings shown (SCSI ID 3,

parity checking enabled, and termination

power disabled)

Pins: Function:

1-2 SCSI ID bit 0

3-4 SCSI ID bit 1

5-6 SCSI ID bit 2

7-8 SCSI ID bit 3

9-10 Parity checking

11-12 Termination Power

(Default)

611