User`s guide

Chapter 2 Installing Internal Tape Drives
Secure the Drive
Quantum DAT 160 User’s Guide 21
Secure the Drive
No Mounting Hardware Used 2
1 Use M3 screws. Check that the holes in the chassis are aligned with
the holes in the sides of the drive and use a regular Phillips
screwdriver to secure the M3 screws (see figure 13
).
Figure 13 Securing Drive, No
Mounting Hardware Used
2 Ensure blanking plates are in place over empty bays and replace the
cover on the server.
Note: The server latches and side views of your server model may
not be exactly the same as shown in the illustrations. Please
refer also to you server documentation.
M3 screws, supplied
with tape drive