User`s guide

Chapter 3 Installing External Tape Drives
Connect the Power Cable
Quantum DAT 160 User’s Guide 32
Figure 19 Two SCSI
Termination Examples for the
External Tape Drives
Connect the Power Cable
An external Quantum DAT 160 drive will operate using any voltage in
the range 100–240 volts (0.7 A, 50-60 Hz). No adjustment is needed. To
connect your drive to the power supply, proceed as follows:
1 Make sure that the drive is switched
OFF (O side down). The power
switch is on the rear panel.
2 Plug the power cable securely into the socket on the rear panel of the
drive.
3 Plug the other end of the power cable into the power outlet.
SCSI Controller
(termination enabled)
SCSI Terminators
External Tape Drive
External SCSI device
External
SCSI device
SCSI Controller
(termination disabled)
Internal SCSI device
(termination enabled)
Example 2: SCSI termination
in a system that has both
internal and external SCSI
devices.
Example 1: SCSI termination
in a system that has only
external SCSI devices.
External
Tape Drive