User's Guide

Commands: Read Position (34h) Page 123
Completion Status
The Completion Status for the READ POSITION command is shown in the following
table.
Code Message Description
00h Good
Status
• The drive is ready to perform any appropriate command.
• The drive remains in any previously set mode.
• The tape is not moved.
02h Check
Condition
Extended Sense Byte 02h:
Code Message Description
02h Not Ready No cartridge is inserted in the drive.
04h Hardware Error Parity error on the SCSI bus or drive
hardware failure detected.
05h Illegal Request
• The CDB contains an invalid bit.
06h Unit
• Cartridge was changed prior to accepting
Attention this command
• The drive was reset prior to this command.