User's Guide

2. Quick Start Installation

This chapter provides quick-start instructions for getting the autoloader tape drives up and running in

the shortest possible time.

Topics in this chapter are:

• “Before you begin” on page 13

• “Autoloader Components” on page 14

• “Installing a Desktop Autoloader” on page 14

• “Installing an Internal Autoloader” on page 15

Before you begin

Precautions

• Do not remove the drive from the antistatic bag until you are ready to install it.

• Before you remove the drive from the antistatic bag, touch a grounded metal surface to

discharge any static electricity buildup from your body.

• Hold the drive only by its edges and avoid direct contact with any electronic components.

• If you need to put down the drive, lay it on top of the antistatic bag or place it inside the bag.

NOTE: If you prefer more detailed instructions, see Chapter 3 for drive installation

instructions.

CAUTION: Observe the following precautions to avoid electrostatic damage to the internal

autoloader.