User's Guide

Installing the Autoloaders Installing the Internal Autoloader
25
Figure 6. Locations of Mounting Holes
Connecting the SCSI Interface Cable
Turn off all power to your computer and drive. Then connect a 68-pin wide internal SCSI cable from
your SCSI controller to the SCSI connector on the back of the autoloader. Be sure pin 1 on the SCSI
controller and cable is connected to pin 1 on the drive. Figure 7 on page 26 shows the location of
SCSI pin 1 on the drive’s SCSI connector. Pin 1 on the SCSI cable should be indicated by a colored
stripe.
The internal autoloader drive can be used with two types of SCSI interfaces:
• Ultra2 SCSI (LVD)
• “Wide” (16-bit) single-ended SCSI
The drive can automatically detect whether it is connected to an LVD or single-ended wide SCSI bus.
NOTE: The internal autoloader will not operate properly in a SCSI-1 environment.
MOUNT HOLE
M3 (4 PLACES)
86
± 0.25
1.8
± 0.25
7.0 ± 0.3
45.5 ± 0.25
203.2 ± 0.25
79.5 ± 0.25
11.9
± 0.3
82.6
± 0.6
21.8
± 0.3
45.5 ± 0.25
M3 (4 PLACES)
MOUNTING HOLE
149.6
± 0.25
203.2 ± 0.5
79.5 ± 0.25
139.7
± 0.3
146 +1
.5 –0.5
1.8
± 0.25
224.0 max
224.0 max