User's Guide

Operating Your Autoloader Applying Labels
30
Applying Labels
When applying labels to a cartridge, observe the following precautions to prevent the cartridge
from getting stuck in the autoloader:
• Apply labels firmly, only in recessed label areas on the top side of the cartridge.
• Do not let labels extend beyond label areas or fold over the edge of a cartridge.
• Do not apply labels over other labels.
Loading a Cartridge
Use only approved DAT cartridges in the autoloader. To load cartridges into the magazine, follow
these steps:
1. Make sure that the cartridges are write-protected or write enabled, as necessary. For more
information, refer to “Write-Protecting a DAT Cartridge and Magazine” on page 33.
2. Hold the magazine so that the slot numbers on the side of the magazine are right-side-up.
3. Insert cartridges with the cartridge door facing the magazine slot, as shown in the following
figure.
Figure 9. Loading a Cartridge into the Autoloader Magazine
CAUTION: Do not place any labels on the autoloader magazine, since this may cause the tape
mechanism to jam.