User's Guide

Understanding the Drive LEDs About the Operator Panel LCD Display
42
DRIVE ERROR04/XX/XX There is a problem with the autoloader. For additional information,
contact Certance Technical Support.
ERASE TAPE X The tape drive is erasing the data cartridge from slot X.
EJECTING MAGAZINE The autoloader is ejecting the cartridge magazine.
EJECT? PRESS ENTER A cartridge resides in the drive and the Eject button has been pressed.
Eject confirmation is required before the cartridge can be ejected.
EJECT PREVENT The autoloader is preventing you from ejecting the magazine because
the software has enabled PMR (Prevent Media Removal).
FAN FAILURE There is a problem with the autoloader fan.Contact Certance Technical
Support.
INSERT EMPTY MAGAZINE The autoloader cannot unload a cartridge from the tape drive to the
magazine because the magazine in the autoloader is fully loaded. Eject
the magazine; then insert an empty magazine into the autoloader
LOADER ERROR04/XX/XX There is a problem with the autoloader hardware. For additional
information, contact Certance Technical Support.
LOAD TAPE X The tape drive is loading the cartridge from slot X.
MEDIA ERROR03/XX/XX There is a problem with the data cartridge. For additional information,
contact Certance Technical Support.
NO MAGAZINE There is no magazine in the autoloader.
READ TAPE X The tape drive is reading from a data cartridge.
READY The autoloader has scanned all cartridge slots in the magazine and is
ready to perform an action.
READY TAPE X There is a cartridge (from slot X) in the tape drive and the autoloader is
ready to accept commands.
REPLACE CLEANING TAPE The cleaning cartridge has been used up and must be replaced with a
new cleaning cartridge.
REWIND TAPE X The tape drive is rewinding the data cartridge from slot X.
SCAN X The autoloader is sequentially scanning the cartridge slots in the
magazine.
SEARCH TAPE X The tape drive is searching the data cartridge from slot X.
SELECT XPUSH ENTER This message displays when the Select button is pressed. Press the
Select button repeatedly to display the desired cartridge location
number (X); then press the Enter button to load the selected cartridge
into the drive.
SELECT PREVENT The autoloader is prevented from ejecting the magazine because the
software has enabled PMR (Prevent Media Removal). Use your backup
software to eject the tape, then press the Eject button to eject the
magazine.
UNLOAD TAPE X The tape drive is unloading the cartridge from slot X.
UPDATING FIRMWARE The autoloader firmware is being updated.
WAITING SELF TEST This message displays while the autoloader is performing a POST
during startup.
WRITE TAPE X The tape drive is writing to the data cartridge from slot X.
LCD Message Description