User's Guide

Chapter 2 Installing Internal Tape Drives
Mounting the Internal Tape Drive
DDS-4/DAT 72 User’s Guide 26
1 Orient the drive so the front of the drive faces the front of the
computer.
2 Insert the drive into the computer’s drive bay.
3 Align the drive’s front panel with the front panel of the computer.
Secure the drive in the mounting bay using two M3.0 metric screws on
each side of the drive (see figure 5
). Figure 6 shows, the 5.25-inch drive
has four screw holes on the bottom and five on each side.
4 Proceed to Connecting a SCSI Cable
.
Figure 5 Mounting an Internal
Tape Drive
Warning: Do not use screws longer than 4 mm; otherwise, you may
damage the drive.