Technical data

16
Chapter 2: Installing the Sled-Mounted DLT2000XT Tape Drive
2. Identify the retaining screw that holds the drive shelf directly above the chosen
drive bay, and remove it with a Phillips screwdriver, as shown in Figure 2-5.
Note: The design of the drive housing precludes placing a DLT2000XT tape drive on
the third drive shelf down from the top, or the bottom drive shelf. Keep this in mind
when preparing for the installation (see Figure 2-7).
3. Pull the drive shelf straight out of the chassis, as shown in Figure 2-6.
Note: Retain the drive shelf if there is a possibility that you will need to install
half-height drives later.
Figure 2-6 Removing the Drive Shelf
SCSI backplane
Drive shelf
Filler plate
Drive shelf
retaining screw