Installation guide

Configuring Your IP4700 Device for Use with Backup Software
23
Configuring Veritas NetBackup Software
You can have only one NDMP backup session running on a given IP4700
SP at a time because only one NDMP session is supported in the IP4700
software.
Testing the Tape Drive Now that you have configured the NetBackup software for a
standalone tape drive, test the tape drive to make sure it works
properly by following these steps:
1. From the NetBackup Administration window, click Device
Monitor.
The Device Monitor displays your configured drives.
2. If the drive state is AVD, meaning that the drive is enabled, or UP,
click the drive row and then right-click and select DOWN Drive
from the menu.
The drive control column changes to DOWN.
a. If a popup window appears indicating that the request has
been queued, recheck the network condition.