Installation guide

34
Configuring Your IP4700 Device for Use with Backup Software
Configuring Veritas NetBackup Software
The Add Drive window appears, as shown in the following
example.
2. Select the device host, which is your NetBackup Master Server.
3. Select the drive type that is appropriate to the robot type (DLT
drive for a TLD robot, and 8mm drive for TL8 robot).
4. Type any name you want for the drive name.
5. For the device name, type ndmp-hostname:tape-drive, the same
as for standalone drives.
6. Check the box, Drive is in a robotic library since this drive is in a
library.
7. Select the robot library.
In the example above, the 0 in TLD(0) indicates robot 0.
8. Select the drive number within the robot.
For now, assume that the library is set up in a logical way, so that
tape drive ID x is Robot drive number x. You add the second
drive to NetBackup the same way you did the first, except that
the device has /dev/c0b0t2d0, and the drive number is 2. Setting
up the third and fourth drives is similar to the first two and
continues in a logical order, except that the NDMP hostname is
dakota11-1b.