Installation guide

Configuring Your IP4700 Device for Use with Backup Software

Configuring Legato NetWorker Backup Software

• Name: use rd=systemname:devicename, where systemname is the

name of the system with the tape drive attached to it (either an

IP4700 SP or a NetWorker system), and devicename is the name of

the device on that system. To find out the name of the device on

an IP4700 system, use the IP4700 web administration program

and look in the Tape Drives area.

• Media type: Type DLT7000 or AIT-2, as appropriate.

• Target sessions: 1.

• NDMP: yes.

• Remote user and Password: The username and password of the

system with the tape drive. For an IP4700, set it to Administrator

and the IP4700’s password. If it is a tape drive on a NetWorker

system with NetWorker SnapImage module, set it to the

username and password established by running the command

/usr/ndmp_home/ndmp_passwd on the NetWorker system.

After running ndmp_passwd, you must restart the NetWorker SnapImage

module daemon. One way to do this is by restarting inetd.

To configure tape drives in a jukebox, follow the jbconfig procedure below.

For more information about jbconfig, refer to the Legato Command Reference

Guide or the jbconfig man pages.

Configuring a Local

Tape Library

To configure NDMP for a local tape library, run the ndmpjbconf and

inquire programs:

%/etc/LGTOuscsi/ndmpjconf

The following Legato example guides you through the prompts.

Enter NDMP Server name: ? dakota11-2a

Enter NDMP user name: ? Administrator

Enter NDMP Jukebox handle: ? /dev/c0b0t1d0

Both ‘ndmpjbconf_dakota11-2a’ file and ‘ndmpjbconf’

default file are created in ‘/usr/lib/nsr.’

%/etc/LGTOuscsi/inquire -N standard

Using ‘/usr/lib/nsr/ndmpjbconf’ default config

file.