Installation guide

48
Configuring Your IP4700 Device for Use with Backup Software
Configuring Legato NetWorker Backup Software
Verify that the values for these attributes are
appropriate for your installation. If not, check
documentation on how to set up automated cleaning
cartridge support.
Jukebox has been added successfully.
Would you like to configure another jukebox?
(yes/no)
no
%
Configuring
Three-Way Backup
For a three-way backup, enter the name of the IP4700 SP with the
tape drive that backups will be sent to in the Storage Node field in
the client resource. Use the NetWorker Administrator program to
modify this field.
Configuring Remote
Backup
To perform remote backup, install and configure the Legato
NetWorker SnapImage Module. During the installation, install only
the NDMP Server. After the installation is complete, set the NDMP
server username and password by running
/usr/ndmp_home/ndmp_passwd on the NetWorker system.
After running ndmp_passwd, you must restart the NetWorker SnapImage
Module. One way to do this is by restarting inetd.
Enter the name of the NetWorker SnapImage Module system in the
Storage node field in the client resource.
Configuring the
Client Resource
Using NetWorker, create a client resource with the following values
(for information about how to create clients, refer to the NetWorker
documentation):
• Name: name of the IP4700 SP
As each SP is an independent backup client, two client resources will be
created for every IP4700.
• Save set: an explicit list of the file systems or directories that will
be backed up; do not use the NetWorker special save set value,
“All.”
• Remote access: root@backupserver where backupserver is the
name of the backup server.