Installation guide

50
Configuring Your IP4700 Device for Use with Backup Software
Configuring Legato NetWorker Backup Software
• NDMP: Select Yes.
•Storage nodes
• For a local backup, enter the SP’s name.
• For a three-way backup, enter the name of the SP with the tape
drive that will receive the backup.
• For a remote backup, enter the name of the NetWorker system
with the tape drive and that is running the NetWorker
SnapImage Module software.
Configuring the Pool
Resource
NetWorker cannot write NDMP and non-NDMP data to the same
tape volume. Also, the backup of the NetWorker Server cannot be
written via NDMP. Therefore, you need at least two pools.
Using NetWorker Administrator, create a pool resource with the
following values:
• Name: IP4700, NDMP, or some other appropriate value
• Pool type: Backup
• Clients: Add the names of each of the IP4700 SPs.
NO_ACLS T/F or Y/N F Do not use this environment variable. If you
do, backups will not save access control list
information for either CIFS or NFS file
systems. We do not recommend using this
variable.
SNAPSHOT T/F or Y/N F (unless
FAST_INCREMENTAL
=T)
If you use this, ensure that the volume has
snapshot enabled in the IP4700 web
interface. (In Volume... List and Modify,
select a volume, click Properties, check
Snap copy, and click Update.)
FAST_INCREME
NTAL
T/F or Y/N F If you use this, ensure that the volume has
Fast Incremental enabled in the IP4700 web
interface. (In Volume... List and Modify,
select a volume, click Properties, check
Fast Incremental, and click Update.)
Note: Snap copy must be enabled in order
to use Fast Incremental.
NDMP
Environment
Variable
Valid
Parameters Default Value Use