Installation guide

52
Configuring Your IP4700 Device for Use with Backup Software
Configuring Legato NetWorker Backup Software
e. Change the Save set field if you want, and type A0 or B0, or
another appropriate value.
f. In the Group field, select Tes t.
g. Click the Preferences tab.
h. In the Server Network Interface field, add the private LAN IP
name or the private LAN IP address for the adapter (if you are
using private LANs).
For the private LAN IP name, use the short host name, not the
fully qualified host name.
9. Start the Te st group.
10. To view performance information for the backup, select the
Monitor tab in the main NetWorker Administrator window.
Under Devices you will see how much of each tape the system is
using; under Sessions you will see all the sessions currently
backing up; and under Messages you will see any information
that NetWorker has reported.
11. View the status of a backup when it is running, has finished, or
has failed.
12. From the NetWorker Administrator window, select Groups.
The system flags each group with one of the following icons:
• ? = group has never run a backup.
• ! = last backup was successful.
• X = part or all of the last backup failed.
• = the backup stopped in the middle of the run.
13. For information about the last backup a group performed, select
Group Details.