User`s guide

Quantum DLT Drives & Media
Troubleshooting DLT Drives
Chapter 22-14
1. Place the DLT drive module on its top side so that the bottom of the
drive module is facing up.
2. Insert a Phillips #2 screwdriver in the rewind hole on the bottom of
the drive module and engage the screw.
NOTE Gently move the ribbon cable to one side of the rewind hole if necessary.
3. Turn the screwdriver counter-clockwise to rewind the tape. Continue
rewinding until the leader is seated in the tape cartridge.
CAUTION Do not use a power screwdriver as damage may result to the tape.
Figure 2-5 Rewinding a Tape in the DLT Drive Module